HEBA Polymerisation Pressure Pot Polypot for Manufacturing Soft Silicone Earmolds

HEBA Polymerisation Pressure Pot Polypot

Pressure polymerization pot for self-curing resin in the water bath for soft earmolds.

No compressed air and electricity supply is required.

Pressure pot made of compact, thermostable plastic, independent of compressed air. No electrical parts. The working pressure of max. 2 bar is generated manually by turning the safety screw downwards giving pressure to the lid and therefore to the water. For the polymerisation of all self-curing resins up to 50 °C/122 °F (e.g. direct relinings).

Technical Data
internal diameter of pot: approx. 100 mm
height of useful space: approx. 65 mm
gross weight: approx. 1.3 kg

According to experiences of polymerisation
Water temperature: 50°C (122 °F)
Pressure load: 2 bar (29 PSI)
Polymerisation time: 12-15 min.

Handling Instructions

1. Apply the resin and place the work into the pot.

2. Make sure that the air removal valve is closed!

3. Fill the pot with adequate hot water until overflowing and close the pot with the lid. A displacer at the

bottom of the lid will push away superfluous water. This overflow prevents air from being enclosed into the

pot.

4. Insert the closed pressure pot into the pressure frame right back to the stop. Apply the necessary

pressure by tightening the screw (maximum pressure load 2 bar).

5. After curing (lime depends on the resin used) open the pressure screw and take the pot out of the

pressure frame. To open the pot, equalize the pressure by turning the release valve (1/2 turn should be

sufficient). Now we recommend closing the air removal valve.

Please note:

Upkeep the Polypot, grease the pressure screw regularly. The pot and lid should not get in direct contact with monomer.